The Experiment That Use Heat Loss plus Heat Gain of a Given Substance Lab Report

The audition That Use Heat Loss plus Heat Gain of a Given Substance and too the Given Phenomenon of Specific Heat in the Laboratory - Lab Report ExampleThe paper tells that a mass of a given metal block got weighed then a piece of twine kindred 30 cm long became attached to it. Then the block became lowered into a steam kettle. The boiler then had half filled pissing. As the water got heated to boil, the mass of an empty calorimeter got measured. The calorimeter got filled two-thirds with water that was several degrees colder compared to room temperature. Then the mass of both water and calorimeter became measured. In the experiment, an outer cap became determined around the calorimeter to prevent heat loss from it when it becomes warmer than room temperature. In the experiment, the two metals used became fuzz and Iron. The mass of copper and iron became 269.53g and 230.80g respectively upon weighing. The mass of calorimeter used became 46.13g. The mass of calorimeter added wa ter for Iron was reasonably more than that of copper. In starting with an original temperature for the calorimeter plus water at 21.9 degrees, in dipping the blocks of metal, the final temperature swaybacked with copper became 30.4 degrees while for iron became 30.1 degrees. In calculating the specific heat of solid for the two experiments, an defect of 0.006cal/g-degrees became found for copper while an mistake of 0.003cal/g-degrees became recorded for Iron. Therefore, iron recorded a percentage error of 2.86% from the accepted value while copper recorded a percentage error of 6.45%.